Set up mustering points

You can set up mustering points to designate locations where employees and visitors will gather in case of an emergency evacuation.

Set up mustering points

1. From the left sidebar in EmergencyOS, click the Settings icon, then select Sites.
   
2. Select the site where you want to set up mustering points.
3. Select the Emergency Settings tab, then under Mustering Points, click Configure.
   
4. In the Edit Mustering Points side panel, take one of the following actions:
   • To edit an existing mustering point, click the Edit icon.

   • To create a new mustering point, click New Mustering Point.

     Note:

     To add a new mustering point, your site must be on the Corporate tier.

5. Fill in the following information:

   • Name: Enter a clear, descriptive name for the mustering point so employees and visitors can easily identify its location.

     Important:

     During an emergency or drill, the default message sent to employees and visitors contains only the names of the mustering points. To provide more detailed instructions on their location, you can edit the messages. For more information, see Configure emergency messaging for an emergency profile.

   • Address: Enter the address of your mustering point. Then adjust the circle on the map to define the exact mustering area.
   • Estimated Time to Mustering Point in Minutes: Enter the number of minutes it should take everyone to reach the mustering point.
   • Safety Officer: Assign one or more Safety Officers who will be responsible for confirming that employees and visitors have arrived at the mustering point.
6. Click Save to close the side panel, then click Save again in the top-right corner of the screen.